Protective finishes / Preparation and protection
Nikkolor Decor Finish — 2.5 L
Water-based protective finish in Matt or Semi-Gloss for compatible Nikkolor surfaces. The manufacturer System Builder allows 16 m2 per 2.5 L for a complete two- or three-coat cycle, before wastage.
- Pack
- 2.5 L
- Indicative
- $262.90
- Freight
- Confirmed at checkout or by quote
Colour and texture vary with lighting and application. Confirm your finish with a physical sample before specifying.
The protective coat that closes a Cemento 3D or MicroCem-FB surface on walls and dry interior floors. Select the specified two- or three-coat cycle in the calculator. Tapioca Matt requires one Semi-Gloss base coat followed by two Matt coats; confirm supply of the separate finishes before ordering.
Nominal coverage and cost basis
- Pack
- 2.5 L
- Manufacturer builder yield
- 16 m2 per 2.5 L for 2–3 coats. Source: nikkolor.net/en/system-builder/.
- Planning basis
- Nikkolor System Builder: 16 m² per 2.5 L for the complete 2–3 coat cycle. Wastage is added separately before rounding up whole tubs; do not multiply consumption by the coat count. Coverage is indicative, not application approval.
- Complete-cycle material cost
- About $16.43 per m2 ($262.90 / 16 m2)
- Previous listing figure
- 11 m2 per pack has no confirmed cycle basis and is not used as a technical consumption rate.
- Between coats
- About 24 hours at +20 C
- After last coat
- 72 hours protected drying at +20 C
Not included
- Roller and tools
- Slip-resistance additive (not offered or rated here)
Where it is used
- Interior walls
- Dry interior floors
Read before specifying
Limits and conditions
- Without a slip-resistance additive, Decor Finish is only for walls and dry interior floors, and wall exposure and substrate restrictions still apply.
- It is not blanket approval for shower walls, wet floors or exterior walls. A slip additive adds slip resistance, but its product name, dosage, tested rating and any approved extra uses are unconfirmed. Do not assume an AS 4586 class.
- For benchtops, pools and other service conditions use VetroLiquido PRP or a written project specification.
Shipping notes
- Freight is quoted for your delivery address and confirmed in our response. Material supply is Australia-wide.
- Pack weights make parcel freight a real cost on larger orders, so confirm the quote before you commit.
Delivery and ordering guidance
Questions
Is Decor Finish a decorative plaster?
No. It is a water-based protective finish. The decorative layer is Cemento 3D, MicroCem-FB or one of the decorative finishes.
Which sheens are available?
Matt and Semi-Gloss.
Can I add an anti-slip additive for a shower floor?
An additive is unconfirmed here: name, dosage, tested rating and approved uses are not established, and it does not approve wet floors, shower floors or exterior use.
